If this is your first visit, be sure to check out the FAQ by clicking the link above.
You may have to register before you can post: click the register link above to proceed.
To start viewing messages, select the forum that you want to visit from the selection below.
is there a way to permanently enable cfw on psp 3000 and if so please please help! When i enable 5.03 gen-a using chickHEN R2 it works until you do a full shut down and turn it back on and its back to ofw.
THIS<---- should help
This plug-in keeps ChickHEN and 5.03 GEN-A or B active. Even if you reboot your PSP-3000
By the way Its called SEDNA
Watch this THIS to see how to install it
i update my psp to gen-c but when i shutdown my psp it lost hen.
Why do you shut it down? Battery still drains even when shut down, just flick the power switch and put it in sleep mode. If you don't use the psp for over a week, then you will notice battery drain, otherwise if you use it every day you will see no difference in battery power loss goinig in standby compared to shutting down.
Its the same as your car, there is always a small amount of power consumption, usually to keep the clock right and to keep engine calibration, when the vehicle is off. Leave it sit there for a month or so and you will need a boost.
With Electronic devices its the same, clocks & other features may need to consume a small amount of juice to keep clocks and settings correct. This of course is not for all but for quite a few, while the consumption is usually too small to notice.
psp 3000 permanent cfw
Linear Mode
