If this is your first visit, be sure to check out the FAQ by clicking the link above.
You may have to register before you can post: click the register link above to proceed.
To start viewing messages, select the forum that you want to visit from the selection below.
-first line of the scramble program pick the name and location of your dump(it doesnt matter what you name it but i normally name them what they are...vshmain.bin, paf.bin and so on)
-second line is the prx you want to edit.
-now click split floats and you will have your .bin file
-now dont close the scramble program or change anything.
-then edit the dump with hex and save
-then go back to the scramble program and click merge floats
-it will now merge your edited .bin file with your prx
-now put you prx into your theme
its pretty simple stuff once you get the hang of it. now when you want to make more edits to the prx after you close the scramble program...simply just edit your .bin file and put it in the first line of the program and the prx it correlates to in the second, and merge the floats again. no need to split them from the prx again as long as you saved your .bin file!
you can also use blessed hands dynamic editor for some of the prx's and it might make your life a bit easier!
-first line of the scramble program pick the name and location of your dump(it doesnt matter what you name it but i normally name them what they are...vshmain.bin, paf.bin and so on)
-second line is the prx you want to edit.
-now click split floats and you will have your .bin file
-now dont close the scramble program or change anything.
-then edit the dump with hex and save
-then go back to the scramble program and click merge floats
-it will now merge your edited .bin file with your prx
-now put you prx into your theme
its pretty simple stuff once you get the hang of it. now when you want to make more edits to the prx after you close the scramble program...simply just edit your .bin file and put it in the first line of the program and the prx it correlates to in the second, and merge the floats again. no need to split them from the prx again as long as you saved your .bin file!
you can also use blessed hands dynamic editor for some of the prx's and it might make your life a bit easier!
Damn.. I still cannot understand this Hex Editing..
So if I want my xmb menu to be in the down right corner, I have to change the value of the Y position to -120 or?
Linear Mode
